Filter
Top Products
92
WARNING:
If the Update Active Trail option box is unchecked, automatic trail
creation and recording will be turned off in both Advanced and
Easy modes. You will have to turn it on again to record trails. The
default setting is on.
Press ↓ or ↑ to
UPDATE ACTIVE TRAIL. With the option highlighted, press
ENT to turn it on (check) or turn it off (uncheck).
Update Active Trail Criteria (Auto, Time, Distance)
The options are automatic, time or distance. When it is in the default
automatic mode, the unit doesn't update the plot trail while you're
traveling in a straight line. Once you deviate from a straight line, the
unit drops a plot point (trail waypoint) onto the trail. This conserves
plot trail points. If a plot trail uses all of the available points allotted to
it, the beginning points are taken away and placed at the end of the trail.
Trail Options menu.
Press ↓ to UPDATE CRITERIA, then press ← → to select the desired criteria
type and press
ENT.
Trail Update Rate (Time, Distance)
You can update a trail by time, with a range from 1 second to 9999 sec-
onds. The default is 3 seconds. You can update by distance, with a
range from 0.01 mile/nm/km to 9.99 mile/nm/km. The default is 0.10
mile.
With Update Criteria selected, press ↓ to either the rate or distance
data entry boxes and press
ENT. Press ↑ or ↓ to change the first charac-
ter, then press → to the next character and repeat until the entry is
correct. Press
EXIT|EXIT to return to the Trails Menu.