Filter
Top Products
130 131
Return to the Top page
Setting Up
Return to the Top page
Setting Up
Language setup
1
Touch [SET] of [Language] in the User
Interface screen.
Language Setting screen appears.
2
Set each item as follows.
Select Mode
Select the mode to select a language.
Easy (Default): Selects a language easily.
Advanced: Allows you to select languages for
respective items.*
Language Select
Select a language.
* If you select [Advanced] for Select Mode,
the following screen appears.
GUI Language Select:
Select the language used for the GUI and
input methods.
ASR:
Select the language used for voice control
function.
Navigation Language Select:
Select the language used for navigation.
STT:
Select the language used for Speech to Text
(STT).
TTS:
Select the language used for Text to Speech
(TTS).
3
Touch [Enter].
NOTE
•To cancel the language setup, touch [Cancel].
Ñ
Touch panel adjustment
1
Touch [Touch] in the System Menu
screen.
Touch Panel Adjustment screen appears.
2
Follow the instruction on the screen
and touch the center of each .
NOTE
•To cancel the touch panel adjustment, touch
[Cancel].
•To reset to the initial status, touch [Reset].
Ñ
Security setup
A red indicator will blink on the unit after the
ACC is set to OFF, warning potential thieves.
If turned to “ON” (default), the security
indicator on the front panel flashes when the
vehicle ignition is off.
1
Touch [Security] in the System Menu
screen.
Security screen appears.
2
Touch [ON] or [OFF] of [SI].
Ñ
EXT SW setup (DNN990HD)
Set up the external switch power mode.
1
Touch [EXT SW] in the System Menu
screen.
EXT SW screen appears.
2
Set each item as follows.
Output Pattern
Set the power signal output mode among
“Pulse”/“Level”. Default is “Pulse”.
You can set to turn output on/off each time
the button on the EXT SW screen is touched.
See External Device Control (P.137).
Pulse Set
Set the pulse signal output time.
Outputs 500ms when “1” is set.
Increases by 200ms with each step. Up to 100
steps can be set.
NOTE
•You can enter characters only after you have
applied the parking brake.
•“Pulse”: Generates a single power signal pulse.
•“Level”: Continues output of high power signal.
Ñ
Setup memory
Audio Control, AV-IN SETUP, Camera, and
Audio SETUP settings can be memorized. The
memorized settings can be recalled at any
time. For example, even when the settings
are cleared due to replacement of the
battery, the settings can be restored.
1
Touch [SETUP Memory] in the System
Menu screen.
SETUP Memory screen appears.
2
Follow the instruction on the screen.
[Lock] / [Unlock]*
Locks or unlocks the AV-IN SETUP, and Audio
SETUP settings.
Yes
Memorizes or recalls the settings.
No
Cancels the function or memorization.
The SETUP Menu screen appears again.
* When [Lock] is selected, you cannot change
the AV-IN SETUP, and Audio SETUP settings.
Also, the locked key mark is displayed
under each setting icon in the setup menu.
Continued