Filter
Top Products
If the position you are using
has a fixed headrest or
head restraint and you are
using a dual tether,
route the tether around the
headrest or head restraint.
1.4. Attach the top tether to the
anchor (A). Make sure that
you secure the top tether to
the top tether anchor and not
to the seatback latch (B).
1.5. Push rearward on the
seatback until it locks
into its upright position.
Push and pull on the
seatback to make sure it is
secured properly.
2. Attach and tighten the lower
attachments to the lower
anchors. If the child restraint
does not have lower attachments
or the desired seating position
does not have lower anchors,
secure the child restraint with the
top tether and the safety belts.
Refer to the child restraint
manufacturer instructions and the
instructions in this manual.
2.1. Find the lower anchors for
the desired seating position.
2.2. Attach and tighten the
lower attachments on
the child restraint to the
lower anchors.
3. Tighten the top tether. If the
headrest interferes with the
installation of the child restraint,
remove the headrest by
pressing the button on the
headrest post, at the top of the
seatback and lift to remove. Store
the headrest under the outboard
side of the rear seat.
4. Push and pull the child restraint
in different directions to be sure
it is secure. When removing
the child restraint, reinsert
the headrest if it has been
removed from the seatback.
H3 Models
1. Attach and tighten the lower
attachments to the lower
anchors. If the child restraint
does not have lower attachments
or the desired seating position
does not have lower anchors,
secure the child restraint with
the top tether and the safety
belts. Refer to the child restraint
manufacturer instructions and
the instructions in this manual.
1.1. Find the lower anchors
for the desired seating
position.
1.2. Put the child restraint on
the seat.
1.3. Attach and tighten the
lower attachments on
the child restraint to the
lower anchors.
Seats and Restraint System 1-39