Filter
Top Products
4. Remove the headrest by
pressing the button on the
headrest post, at the top of the
seatback, and lift to remove.
5. Lift the headrest off of the
seatback and store on the back
panel.
To return the seatback(s) to the
upright position:
1. Lift the seatback partially and
reinsert the headrest.
2. Lift the seatback completely and
push it into place.
{ CAUTION
If either seatback is not locked, it
could move forward in a sudden
stop or crash. That could cause
injury to the person sitting there.
Always push and pull on the
seatbacks to be sure they are
locked.
3. Make sure the seatback is locked
by pushing and pulling on it.
{ CAUTION
A safety belt that is improperly
routed, not properly attached, or
twisted will not provide the
protection needed in a crash.
The person wearing the belt could
be seriously injured. After raising
the rear seatback, always check
to be sure that the safety belts
are properly routed and attached,
and are not twisted.
4. Reconnect the center safety belt
latch plate to the mini buckle.
Make sure the safety belt is not
twisted.
5. Push and pull on the latch plate
to be sure it is secure.
When the seatback is not in use,
it should be kept in the upright,
locked position.
1-10 Seats and Restraint System