Filter
Top Products
contact XM at.xmradio.com or call
1-800-929-2100 in the U.S. and
xmradio.ca or call 1-877-438-9677
in Canada.
4 (Information) (XM Satellite
Radio Service): Press to display
additional information current
XM station when
4 is shown on the
display. When the complete
message has shown,
4 disappears
from the display. The last
message can be viewed until a new
message is received or the station
is changed.
• Parts of the message appear
every three seconds if the
entire message cannot be shown
on the display at once.
• Press and release 4 to manually
scroll through the message.
• When 4 is pressed and a
message is not available from the
station, NO INFO is shown on
the display.
Selecting an FM/AM/XM Station
BAND: Press to select FM1,
FM2, AM, XM1, or XM2.
Manual Tuning
e (Tune): Turn to select a radio
station.
Automatic Tuning
1-6 (Preset Pushbuttons): Press
to select preset stations.
t SEEK u: Press and release to
go to the previous or next station
and stay there. The radio only stops
at stations with a strong signal.
Press and hold to scan stations or
preset stations.
To scan stations:
1. Press and hold
t or u for more
than two seconds. SCN or SCAN
displays and the radio beeps
once. The radio goes to a station,
plays for a few seconds, then
goes to the next station.
2. Press
t or u again or one of
the pushbuttons to stop
scanning presets.
To scan preset stations:
1. Press and hold
t or u for more
than four seconds. PSC or
PSCN displays and the radio
beeps twice. The radio goes to a
preset station, plays for a few
seconds, then goes to the
next preset station.
2. Press
t or u again or one of
the pushbuttons to stop
scanning presets.
Programming Preset Stations
Up to 30 stations (six FM1, six FM2,
and six AM, six XM1 and six XM2),
and equalization settings for
each station can be programmed on
the six numbered pushbuttons.
To program presets:
1. Turn the radio on.
2. Press BAND to select FM1, FM2,
AM, or XM1 or XM2.
Instrument Panel 3-45