Filter
Top Products
Garmin G1000 Cockpit Reference Guide for the Mooney M20M, M20R, & M20TN
9-2
SECTION 9 – PROCEDURES
6) A second window is displayed listing available
transitions for the arrival. Turn either
FMS
Knob
to highlight the desired transition waypoint and
press the
ENT
Key.
Figure 9-4 Select Arrival Transition
7) A third window is displayed listing the available
runways. Turn either
FMS
Knob to select the
desired runway and press the
ENT
Key.
Figure 9-5 Select Arrival Runway
8) With ‘LOAD?’ highlighted, press the
ENT
Key.
If a flight plan is active, the selected arrival
procedure is inserted after the destination
airport and becomes part of the active flight
plan. If no flight plan is active when the arrival
is loaded, the arrival procedure will become the
active flight plan.
9.2 APPROACHES
Not all approaches in the database are approved for GPS
use. When selecting an approach, a “GPS” designation to
the right of the procedure name indicates the procedure
can be flown using the GPS receiver. Some procedures
will not have this designation, meaning the GPS receiver
can be used for supplemental navigation guidance only.
If the GPS receiver cannot be used for primary guidance,
the appropriate navigation receiver must be used for the
selected approach (e.g., VOR or ILS). The final course
segment of ILS approaches, for example, must be flown
by tuning the Nav receiver to the proper frequency and
selecting that Nav receiver on the CDI.
Load and/or Activate an Approach Procedure
1) With the Navigation Map Page displayed, press
the
FPL
Key.
2) Press the
LD APR
Softkey. If a flight plan is
active, the destination airport will be displayed
as the default. A list of available approaches
is also displayed.
3) If no flight plan is active, use the
FMS
Knob to
enter the identifier of the desired airport. Press
the
ENT
Key.
4) Turn the
Large FMS
Knob to highlight the
Approach field. Turn the
Small FMS
Knob to
display a list of available approaches.