Filter
Top Products
Garmin G1000 Cockpit Reference Guide for the Mooney M20M & M20R
1-5
SECTION 1
SYSTEM OVERVIEW
PFD
Press the STD BARO or BACK softkeys
to return to the top level softkeys
Press the DFLTS softkey to change the PFD
metric values to standard
ARC HSI
360 HSI
STD BARO
BACK
ALERTS
BRG2
BRG1
METRIC
DFLTS
DME
(optional)
Figure 1-4 PFD Softkey Flow Chart – 2
NAV1
– Displays NAV1 waypoint frequency or
identifier and DME information in the BRG1
information window.
GPS
– Displays GPS waypoint identifier and GPS
distance information in the BRG1 information
window.
ADF
– Displays ADF waypoint frequency in
the BRG1 information window.
OFF
– Removes the BRG1 information
window.
360 HSI
– Press to display the 360° compass rose.
ARC HSI
– Press to display the 140° viewable arc.
BRG2 (bearing)
– Press to cycle through the follow-
ing Nav sources, making the pointer the indica-
tor for the corresponding source and displaying
the the appropriate information.
NAV2
– Displays NAV2 waypoint frequency or
identifier and DME information in the BRG2
information window.
GPS
– Displays GPS waypoint identifier and GPS
distance information in the BRG2 information
window.
ADF
– Displays ADF waypoint frequency in
the BRG2 information window.
OFF
– Removes the BRG2 information
window.
STD BARO
– Press to set the barometric pressure
to 29.92 inches of mercury (1013 hPa by
pressing the
METRIC softkey).
BACK
– Press to return to the previous level
softkeys.
OBS – Press to select OBS mode on the CDI when
navigating by GPS (only available with active leg).
CDI – Press to change navigation mode on the CDI
between GPS, VOR1 and VOR2.
ADF/DME (optional) – Press to display the ADF/DME
Tuning window.
XPDR – Press to display the transponder mode selec-
tion softkeys.
STBY
– Press to select standby mode.
ON
– Press to select mode A.
ALT
– Press to select altitude reporting mode.
VFR
– Press to automatically squawk 1200 (only
in the U.S.A., refer to ICAO standards for VFR
codes in other countries).
CODE
– Press to display transponder code selection
softkeys 0-7.
0 through 7
– Press numbers to enter code.
IDENT
– Press to provide special aircraft
position identification to Air Traffic Control
(ATC).
BKSP
– Press to remove numbers entered one
at a time.