Filter
Top Products
Quest Owner’s Manual 37
CUSTOMIZING YOUR QUEST> CUSTOMIZING THE OVERALL SYSTEM SETUP
Customizing the Overall System Setup
You can customize various system setup features on your Quest.
Press MENU two times, highlight System Setup, and press OK.
GPS Mode—sets GPS to Normal, WAAS, Battery Saver (which
periodically turns off the GPS receiver to save battery power), or
GPS Off. See “Understanding GPS” beginning on page 42 for
more information.
Voice Guidance
—determines when the Quest “speaks.”
• Automatic with Chime: The unit chimes and then speaks
status messages and guidance messages during route
navigation. For each turn on a route, the voice gives
instructions three times: after you have completed a turn, as
you are approaching the next new turn, and just before you
reach the next turn.
• Automatic: The unit speaks guidance messages during route
navigation, as described above. It does not give chimes.
• Button Only: The unit only speaks when the Speak key
is pressed.
External Power Lost
—if Turn Off is set, the unit shuts down
after 30 seconds when the Quest loses external power. If Stay On
is set, the Quest runs on battery power when external power is lost.
Text Language
—changes all on-screen text to the selected
language. Changing the text language does not affect the display of
map data or user-entered data. Map data is always displayed in the
language in which it is stored in the map.
Voice Language
—(Quest 2 Only) changes the spoken language.
Keypress Tone—turns the keypress beep On or Off.
Safe Mode—turns the Safe Mode on and off. When your vehicle
is moving, Safe Mode disables all Quest functions that require
significant operator attention and could distract the driver. When
you come to a complete stop, these features are automatically
enabled. Set to Off to allow a passenger to operate the unit.
To restore these settings, press the
MENU key, highlight Restore
Settings, and press OK.