Filter
Top Products
6 Quest Owner’s Manual
UNIT OVERVIEW > GETTING STARTED
Getting Started
Turning the Quest On and Off
Press and hold the Power
key on the front of the unit to turn
it on or off. When turned on, the Welcome page appears briefly,
followed by a Safe Driving Warning Message. Press the OK key
to acknowledge the message, or wait briefly until the Map page
appears. Your Quest automatically starts searching for satellite
signals to find your current location.
Adjusting the External Speaker Volume
You can adjust the volume for the external speaker using two
different methods. Be sure that you properly adjust the volume on
both controls.
You can adjust the volume using the volume
control knob on the external speaker. Test the
sound level by pressing the Speak key.
You can also press and hold the
Speak
key to open the volume slider. Press the
Rocker pad right to raise the volume or left
to lower it. You can quickly press the Speak
key to adjust the volume to a pre-set level
(low, medium, and high).
Turning Off Satellite Reception for Indoor Use
You can set your Quest for indoor use which stops satellite
reception. As a result, it conserves the battery and speeds up the
searching and mapping operations. Thoroughly familiarize yourself
with the routing features of the Quest by creating practice routes in
simulator mode (Use Indoors).
To turn off satellite
reception:
1. Press the Page
key to
open the Map page.
2. Press the MENU key.
3. Highlight Use Indoors
and press the OK key.
The GPS function is
disabled.
To turn on satellite reception:
1. Press the Page
key to open the Map page.
2. Press the MENU key.
3. Highlight Acquire Satellites and press OK. The GPS
function is enabled and your Quest begins to acquire
satellites.
Volume
control
Speaker