Filter
Top Products
4 Quest Owner’s Manual
UNIT OVERVIEW > VEHICLE INSTALLATION
Vehicle Installation
Select a suitable location for installing the unit that allows routing
of the power cord and does not interfere with vehicle operation.
Refer to the warnings on pages iv–v.
If you are NOT using a remote antenna, be certain to select
a location where the Quest’s flip-up antenna has a relatively
unobstructed view of the sky. For optimal use, position the
antenna parallel to the surface of the road.
NOTE: An optional external remote antenna (Garmin GA 27C)
may be needed when using the unit in a vehicle with a coated
windshield or an in-screen heating system.
To snap the cradle on the suction mount:
1. Align the ball on the end of the suction mount with the
socket (hole) on the back of the cradle.
2. Press firmly to snap the ball into the socket.
To insert the Quest in the cradle:
Suction
cup
Lever
Release
tab
Cradle
Suction
cup tab
1. Flip up the antenna.
2. Angle the Quest forward as shown above. Fit the bottom of
the Quest into the cradle.
3. Tilt the unit back until it snaps into the cradle.
To mount the vehicle suction mount:
1. To ensure a tight grip, clean and dry your windshield.
2. Pull the lever on the suction cup toward you. Place the
suction cup on your windshield.
3. Flip the lever toward the windshield. Rotate the cradle to
obtain a maximum viewing angle.
4. Plug the power cable into an available receptacle.