Filter
Top Products
1. OPERATIONAL OVERVIEW
1-5
1.2 Inserting a Chart Card
Your unit reads FURUNO and Nav-Charts™ (NAVIONICS) chart cards, or
C-MAP chart cards, depending on the type of display unit you have. Insert the
appropriate chart card for your area as follows:
1. Open the chart drive.
Chart drive
Display unit
2. Insert desired chart card groove side up.
3. Close the lid to protect the chart drive.
Note 1: Do not remove a card while the chart is being drawn. This may cause
the equipment to freeze.
Note 2: Do not insert or remove a card while the power is on. This may cause
the equipment to freeze.
Note 3: For multiple display units, do not use the same chart card type in more
than one display unit.
Note 4: A card remover is supplied to ease removal of chart cards. Attach the
card remover to the right-hand side hole of the card and pull it to remove
the card. You can leave the remover attached to the card while the card
is in the chart drive. Push the remover leftward until it contacts the
recessed area on the card.
Chart card and card remover