Filter
Top Products
3. PLOTTER OPERATION
3-22
4. Use the trackball to select digit and enter value with the alphanumeric keys.
The CLEAR soft key functions to clear an entire line of data.
5. Push the [ENTER] knob or ENTER soft key.
6. Press the [MENU] key to close the menu.
3.6.5 Changing own ship track/mark distribution setting
The equipment stores a total of 8000 points of track and marks. This amount
may be distributed as desired, and the default setting is 2000 points of track and
6000 points for marks.
When you change the track memory setting, all tracks and marks in the memory
are erased. If necessary save the data to a memory card. For further details see
the paragraph “6.1.2 Saving data to a memory card.”
1. Press the [MENU] key followed by the CHART SETUP and TRACKS &
MARKS CONTROL soft keys to open the TRACK CONTROL menu.
2. Use the trackball to select MEMORY (TRACK & MARK).
3. Press the EDIT soft key to display the track memory window.
2000/8000 POINTS
TRACK MEMORY
Track memory window
4. Use the trackball to select digit and use the alphanumeric keys to enter
value.
5. Push the ENTER soft key or the [ENTER] knob. You are asked if you are
sure to change the track memory capacity.
6. Push the [ENTER] knob.
7. Press the [MENU] key to close the menu.