Filter
Top Products
69
Notes:
• MacandLinuxusersshouldalwaysselectoneoftheMassStorageoptionsfortheUSB
setting (depending on if you are saving data on internal or removable memory).
• IfyouwanttoaccessthelesonyourSDcardandyoudonothaveanSDcardreader,select
Mass Storage: SD/MMC Card as the USB setting.
• SelectDeLorme if you are using the device with compatible DeLorme mapping software.
3. Press QUIT to return to the Device Setup Page.
To Modify the Sound Settings
Use the following instructions to modify the device’s button press sound, message sound, power
sound, turn alert sound, and/or the volume of all sounds.
1. From the Device Setup Page, highlight the Sound option and press ENTER.
2. To modify the button press sound, highlight the Button Press drop-down list and press
ENTER. Highlight the sound type you want and press ENTER.
3. To modify the message sound, highlight the Message drop-down list and press ENTER. Then,
highlight the sound type you want and press ENTER.
4. To modify the Power sound, highlight the Power drop-down list and press ENTER. Then,
highlight the sound type you want and press ENTER.
5. To modify the turn alert sound, highlight the Turn Alert drop-down list and press ENTER.
Then, highlight the sound type you want and press ENTER.
6. To modify the volume of all sounds, highlight the Volume slider control and press the arrow
keypad to the right to increase the volume (or to the left to decrease the volume).
7. To mute the sound, highlight the Mute field and press ENTER. Note: This does not mute
the warning sound when power is critically low. To enable sound again when the check box is
selected, highlight the Mute field and press ENTER to clear the check box.
8. Press QUIT to return to the Device Setup Page.
The Device Setup Page
Soundmenuoptions