Filter
Top Products
10.
Remove the two
screws at the
engine cover.
Some vehicles
may have
hex-head bolts
instead
of
screws.
The screws (or
bolts) are not
supposed to come
out
of
the cover,
only from the
front of the dash.
When removing the cover, be careful not to damage
the
instrument
panel or the trim.
I
1.
Grasp the bottom
of
the cover and
slide
it
backwards. Then,
lift
it
up and out
of the vehicle.
To Install the Engine Cover:
1.
Lift the engine cover into the vehicle and slide
it
all the way forward.
Make sure the rubber seal is over the latches.
2.
Install
the
two screws at the engine cover.
Do
not tighten the screws all
the way.
sure they are secure.
3.
Press down on each
of
the two latches at the bottom of the cover. Make
4.
Tighten the two screws at the engine cover.
5.
Turn
the
bracket into position and install the bolt. Tighten the
nut
at
the
other end
of
the bracket.
6-16