Filter
Top Products
To
PIay
A
Cassette
Your tape player is built to work best with tapes that are
30
to
45
minutes
long on each side. Tapes longer than that are
so
thin
they may not work well
in
this player.
Once the tape is playing, use the upper and lower knobs for volume, balance
and fade just as you do for the radio. A lighted arrow shows which direction
the tape is being played.
FORWARD
-
To
rapidly advance the tape, press
4
or
b
in
the direction
that the amber arrow points and the tape will rapidly go forward until
you
press the STOP-EJECT button lightly.
REVERSE
-
To rapidly reverse the tape, press
4
or
b
in
the opposite
direction that the amber arrow points and the tape will rapidly reverse until
you
press the STOP-EJECT button lightly.
PROGRAM
-
To
go from
one
side
of
the tape
to
the other, press the
VOL-PROG-RCL knob.
STOP-EJECT
-
To remove
the
tape or stop the tape and switch to radio,
press the STOP-EJECT button.
If a tape
is
inserted with side
“1”
(or
“A”)
up, then the right arrow means
that that side is being played. Likewise,
a
left arrow would indicate that side
“2”
(or
“B”)
had been selected. The player
will
automatically switch to the
other side
of
the tape when the first side ends.
If “Cln” (Clean) appears
on
the
display
when
you insert your cassette tape,
your cassette player needs to be cleaned. It will
still
play cassette tapes but
it
should be cleaned to prevent damage to your cassette tapes and the cassette
tape player. See “Care
of
Your Cassette Tape Player” later in this section.
After you have cleaned the cassette tape player, press and hold
STOP-EJECT for
5
seconds
to
reset the the “Cln” indicator. The radio will
display
“-
-
-”
to
show the clean feature has been reset.
3-1
1