Filter
Top Products
Trailer Wiring Harness
If you have the optional trailering package, your vehicle will have an 8-wire
harness, consisting of a 7-wire harness and one
CHMSL
battery feed wire.
The harness is stored
on
the passenger side
of
the van near the rear wheel
well. This harness has a
30
amp battery feed wire and
no
connector, and
should
be
wired by a qualified service person. Attach the harness to the
trailer, then tape or strap it
to
your vehicle’s frame rail. Be sure you leave it
loose enough
so
the wiring doesn’t bend or break, but not
so
loose that it
drags
on
the ground.
The harness must be routed out of your vehicle between the rear door and
the floor, with enough of the harness left on both sides
so
that the trailer or
the body won’t pull it.
Store the harness in its original place. Wrap the harness together and tie it
neatly
so
it won’t be damaged.
2-63