Filter
Top Products
Pushbuttons
-
The four pushbuttons
let
you
return
to
favorite stations. To
set the pushbuttons for up to fourteen favorite stations
(7
AM and
7
FM):
1.
Tune
in
the desired station.
2.
Push the SET button. “SET” appears in the display for about
5
seconds.
3.
Within
the
5
seconds, push one of the four pushbuttons. Whenever
you
press that button, the preset station will return.
In addition to the four stations set as above, up to three additional stations
may be preset
on
each band by pressing two adjoining pushbuttons at the
same time. Then do the following:
1.
Tune in the desired station.
2.
Press the
SET
button.
3.
Within
5
seconds, press any two adjoining pushbuttons
at
the same time.
(The station will return when the same two buttons are pressed again.)
To
Adjust the Tone
-
Use the levers
in
the upper middle left corner
to
set
the
bass, midrange, and treble until you get the sound you want. The
60
and 250
levers adjust the bass,
1
K
is midrange, and
3.5K
and
1
OK
control the treble.
We suggest
you
start with the center lever (1K) in the midpoint position,
then move the others up until
you
get
the
amount of bass and treble you like.
Am-St Button
-
Push the Am-St button when
you
tune
to
an
AM
station
that broadcasts in stereo. Your STEREO light will come on when you’re
receiving AM stereo. If you push Am-St and there is
no
more noise,
it
means the station is weak. You’ll hear the station better if
you
don’t use
Am-St. Just push the Am-St button again to delete stereo.
To
Play
A
Cassette
Your tape player is built to work best with tapes that are
30
to
45
minutes long
on
each side. Tapes longer than that are
so
thin they may
not
work well
in
this player.
Once the tape is playing, use
the
upper and lower knobs for volume, balance
and fade just as
you
do for the radio. A lighted arrow shows which direction
the tape
is
being played.
CrO2
-
The CrO2 button lets
you
set the system for
the
type of cassette
being used. If you are using chrome
or
metal tapes, push the Cr02 button
in.
FWD
-
To
rapidly advance the tape, press
4
or in the direction that
the
amber arrow points and the tape will rapidly
go
forward until you press the
STOP-EJECT button lightly.
REV
-
To rapidly reverse the tape, press
4
or
b
in the opposite direction
that
the
amber arrow points and the tape will rapidly reverse
until
you
press
the
STOP-EJECT button lightly.
APS
-
Press the APS button to the recessed position.
Press
4
or
b
in
the direction that
the
amber arrow points to go to the
beginning
of
the next selection.
3-13