Filter
Top Products
Headlamps
4.
Connect the new headlamp assembly
to
the wiring
harness, making sure the connector tab snaps
into place.
5.
Insert the headlamp into the slots
in
the fascia.
6.
Slide the retainers downward until they are
fully seated.
Front Parking and Turn Signal
Lamp
1.
Remove the headlamp assembly. Refer
to
the
removal procedure earlier in this section.
2.
Remove rubber bulb access cover.
3.
Twist and pull the sidemarker lamp socket from the
4.
Holding the base
of
the bulb, pull the bulb from
headlamp assembly.
the socket.
1.
Pull up on the headlamp retainers
to
release
the
assembly locator tabs.
2.
Slide the headlamp assembly out of the slots.
3.
Lift the plastic locking tab on
the
electrical
connector and pull the connector from the headlamp
bulb socket.
5.
Push the new bulb into the socket.
6.
Put the socket back into the headlamp assembly and
turn it to the right until it
is
secure.
7.
Replace the rubber bulb access cover.
6-31