Filter
Top Products
PUSHBUTTONS:
The six numbered pushbuttons
let
you return to your favorite stations. You can
set
up
to
18 stations (six AM, six
FM
1 and six
FM2).
Just:
1.
Turn the radio on.
2.
Press AM-FM to select the band.
3.
Tune in the desired station.
4.
Press and hold
one
of
the six numbered buttons. The
sound will mute. When it returns, release the button.
Whenever you press that numbered button, the
station
you
set will return.
5.
Repeat the steps for each pushbutton.
P
SCAN:
Press this button
to
listen
to
each of your
preset stations for a few seconds. The radio will go to
the first preset station, stop for a few seconds, then
go
on to the next preset station. Press
P
SCAN
again
to
stop
scanning. The radio will
not
stop at a preset if
the
station
is weak.
Setting the Tone
BASS:
Press this knob lightly
so
it extends. Turn the
knob
to
increase or decrease bass.
TREB:
Press this knob lightly
so
it extends. Turn
the
knob to increase or decrease treble. If a station is weak
or
noisy, you may want to decrease the treble.
Push these knobs back into their stored positions when
you’re not using them.
Adjusting the Speakers
BAL:
Turn the control behind the upper knob to move
the sound
to
the left or right speakers. The middle
position balances the sound between the speakers.
FADE:
Turn the control behind the lower knob to move
the sound to the front or rear speakers. The middle
position balances the sound between the speakers.
Playing a Cassette Tape
The longer side with the tape visible should face
to
the
right. If the ignition and the radio are on, the tape can be
inserted and will begin playing. If
you
hear nothing or
hear a garbled sound,
the
tape may not be in squarely.
Press
EJECT
to remove the tape and start over.
3-16