Filter
Top Products
RECALL:
Press this button briefly to recall the station
being played or to display the clock. To change what is
normally shown on the display (station or time), press
the button until
you
see
the display you want, then hold
the button until the display flashes. If you press the
button when the ignition is off, the clock will show for a
few seconds.
Finding
a
Station
AM-FM:
Press this button to switch between AM, FMl
and
FM2.
The display shows your selection.
TUNE:
Press the up or down arrow to choose
radio stations.
SEEK:
Press the up or down arrow to go to the next
higher or lower station and stay there. The sound will
mute while seeking.
SCAN:
Press one
of
the
SEEK
arrows for two seconds
and SCAN will appear on the display. Use SCAN to
listen to stations for a few seconds. The radio will go to
a station, stop for a few seconds, then go on to the next
station. Press one of the
SEEK
arrows again to stop
scanning. The sound will mute while scanning.
PUSHBUTTONS:
The six numbered pushbuttons let
you
return to your favorite stations. You can set up to
18
stations (six AM, six FM1 and six FM2). Just:
1.
2.
3.
4.
5.
6.
Turn the radio
on.
Press AM-FM to select the band.
Tune
in the desired station.
Press
TONE
to select the setting you prefer.
Press and hold one of the six numbered buttons. The
sound will mute. When it returns, release the button.
Whenever you press that numbered button, the
station you set will return and the tone you selected
will be automatically selected for that button.
Repeat the steps for each pushbutton.
P
SCAN:
Press this button to listen to each of your
preset stations for a few seconds. The radio will go
to
the first preset station, stop for a few seconds, then go
on to the next preset station. Press P SCAN again to stop
scanning. If
a
preset station has weak reception, the
radio will not stop at the preset station.
3-23