Filter
Top Products
54
POSITION SENSOR SETUP
In order to correctly position the drive output
shaft in response to the input Demand signal,
the DCM-2 board receives a position signal from
the drive’s position sensor (CPS) and compares
this actual position to the desired Demand input.
This process requires that the DCM-2 interprets
the CPS signal appropriately for the full range
of desired travel. The "PositionSensrSetup"
submenu is used to set the DCM-2 to accept the
CPS position signal and interpret the appropriate
0–100% range.
All Beck drives are shipped completely set
and calibrated to the customer specifications
and are ready for installation. Normally, no
adjustments are necessary.
If, however, the position calibration needs to
be changed, the "PositionSensrSetup" submenu
must be used. The "PositionSensrSetup" is
accessible through the "Configuration" menu.
DCM-2 HART INTERFACE Calibration - Position
The "PositionSensrSetup" submenu will allow
resetting of the minimum travel position of the
drive (Set Pos 0%) and the CPS voltage at the
minimum travel position (CPS Zero%). Online
help is available through the communication
device.