Filter
Top Products
54 Additional Safety Features
Comfort Clip Operation
When provided, the comfort clip is located
on the shoulder strap just below the D-ring.
When adjusting the comfort clip, the fol-
lowing procedure must be followed for
proper adjustment:
1 Pull out only enough webbing to allow
slight pressure to the shoulder and
chest. Allow no more than a 1 in.
(25 mm) slack when measured be-
tween the chest and the belt.
2 To activate the clip mechanism feature,
lift the lever up to clamp the webbing
in place.
NOTE! When the safety belt is not in use,
the clip should be in the open position to
allow the seat belt to retract to its proper
position. Also make sure that the adjust-
ment of the comfort clip does not interfere
with the operation of the safety belt.
W8002388
Open position
Always adjust the clip so that there is a
maximum of 1 in. (25 mm) of slack be-
tween the belt and chest (about two fingers
width). If a larger slack is allowed, the ef-
fectiveness of the safety belt is decreased in
the event of a collision.
W8001837