Filter
Top Products
02 Instruments and controls
52
Trip computer
02
Trip computer (option)
Controls
To scroll through trip computer information,
turn the thumbwheel (B) in steps, either up-
ward or downward. Continue turning to re-
turn to the starting point.
Functions
The trip computer displays the following in-
formation:
• AVERAGE SPEED
• SPEED IN MILES PER HOUR
1
• INSTANTANEOUS
• AVERAGE
• KILOMETRES TO EMPTY TANK
• STC/DSTC, see page 126
Average speed
The average speed since the last reset
(RESET). When the ignition is switched off,
the average speed is stored and used as the
basis of the new value when you continue
driving. This can be reset with the RESET
button (C) on the stalk switch.
Speed in miles per hour
1
Current speed is displayed in mph.
Instantaneous
Continuous information on current fuel con-
sumption, calculated each second. The fig-
ure in the display is updated every couple of
seconds. When the car is stationary, "----" is
shown in the display.
Average
The average fuel consumption since the last
reset (RESET). The average fuel consump-
tion is stored when the ignition is switched
off and remains until the function is reset. Re-
set using the RESET button (C).
Kilometres to empty tank
The range to empty is calculated based on
the average fuel consumption over the last
30 km. When the range to empty is shorter
than 20 km then "----" is shown in the
display.
NOTE
If a warning message interrupts while you
are using the trip computer, this message
must be acknowledged. Acknowledge by
pressing the
READ button (A) and revert to
the trip computer function.
1
Certain countries.
NOTE
There may be a slight error in the reading if
a fuel-driven heater is used.
NOTE
There may be a slight error in the reading if
a fuel-driven heater is used.
NOTE
There may be a slight error in the reading if
fuel consumption is changed due to a
change in driving style or if a fuel-driven
heater is used for example.