Filter
Top Products
07 Wheels and tyres
164
Changing wheels
07
Fitting the wheel
– Clean the contract surfaces on the wheel
and hub.
– Fit the wheel. Screw the wheel nuts.
– Lower the car so that the wheel cannot
rotate.
– Tighten the wheel nuts crosswise. It is
important that the wheel nuts are tight-
ened properly. Tighten to 140 Nm. Check
the torque with a torque wrench.
– Put on the wheel cover (steel rim).
Certain variants.
WARNING
Never crawl under the car when it is raised
on the jack.
Passengers must leave the car when it is
raised on the jack.
Ensure that passengers wait with the car -
or preferably a crash barrier - between them
and the road.
IMPORTANT
If TPMS is specified then the tyres must be
calibrated after fitting. Read "Adjusting tyre
pressure", see page 161.