Filter
Top Products
09 Maintenance and service
189
Replacing bulbs
09
Dipped beam, halogen
To remove the bulb
– Switch off all lights and turn the ignition
key to position 0.
– Remove the cover.
– Unplug the connector.
– Disconnect the spring clamp. First push to
the right so that the spring disconnects
and then out and down.
– Pull out and remove the bulb.
To fit
– Fit the new bulb. In can only be positioned
one way.
– Press the clamp spring upwards and a
little to the left so that it secures in its
catch.
– Plug in the connector.
– Refit the cover.
Main beam
To remove the bulb
– Switch off all lights and turn the ignition
key to position 0.
– Remove the cover.
– Turn the bulb anticlockwise and pull it out.
– Undo the connector by pressing the catch
out and then pulling.
To fit
– Plug the connector into the bulb, a click is
heard.
– Refit the bulb, turn it in position.
–Refit the cover.