Filter
Top Products
y OverSpeed
This message is displayed when the
vehicle’s speed is greater than
the set OverSpeed value. See
“OverSpeed” under DIC Operation
and Displays on page 4-22.
You can press
8 or move the
thumbwheel up
Q or down R to
acknowledge that you received
the message, but OverSpeed will
continue to appear in the bottom of
the DIC display as long as the
vehicle’s speed exceeds the
preset value.
$ Park Brake
This message is displayed if the
parking brake is applied when you
are driving. Release the parking
brake. See Parking Brake on
page 8-11.
Replace Battery in Remote Key
This message is displayed when the
battery in the remote keyless entry
transmitter needs to be replaced.
See your dealer/retailer to replace
the battery.
You can press
3 or 8 to
acknowledge that you received the
message, but
Q Key Batt will
continue to appear in the bottom
of the DIC display until the battery
has been replaced.
w Rest Reminder
This feature reminds the driver
that they may have been driving
for too long without a break.
When the ignition is turned on, a
timer starts counting. After two hours
of continuous driving, the rest
reminder flashes to alert the driver.
The Rest Reminder message is
displayed until
3 or 8 are
pressed. The rest reminder
reappears after 20 minutes
accompanied by a chime, unless
the ignition has been turned off.
For information on how to turn the
rest reminder on and off, see DIC
Vehicle Customization on page 4-31.
{ Safety Mode Active and
Power Reduced
These messages display alternately
when there is a problem with the
engine control system, see your
dealer/retailer.
You can press
3 or 8 to
acknowledge that you received the
message, but
{ Safety will
continue to appear in the bottom of
the DIC display until the vehicle
has been serviced.
Instruments and Controls 4-29