Polaris SL2 Automobile User Manual


 
58
MAINTENANCE
Drive Belt Condition
Adjust drive belt tension after the first 2,500 miles
(4,000 km) of operation. Replace the drive belt and both
sprockets as a set if the drive belt has over 30,000 miles
(48,000 km) of service at the time of damage or failure.
Replace the drive belt if any inspection reveals cracks,
broken teeth or frayed edges. See the SLINGSHOT
Service Manual or an authorized dealer.
DO NOT attempt to check belt tension if the belt has
been exposed to rain or washing within a 24 hour period
or if the belt is hot from being in use. Allow the belt to
cool down to ambient temperature before measuring
belt tension.
Drive Belt Wear Analysis
Drive Belt Cleaning
Cleaning the drive belt will maximize belt and sprocket life and minimize drive line noise.
Clean the belt at every tire change. Clean the belt more often if operating in dirty, dusty or
high debris environments.
1. Mix a few drops of mild dish soap with a cup of warm water.
2. Use a soft nylon brush to clean the belt and sprocket teeth with the soapy water. Clean
well in corner areas where road debris and belt dust can collect.
3. Rinse the belt with clear water, then dry thoroughly.
NOTE: Do not inspect or adjust drive belt tension when the belt is wet. Improper adjustment will result.
Internal tooth cracks
(hairline):
OK to run, but
monitor condition
External tooth cracks:
Replace belt
Missing teeth:
Replace belt
Chipping (not serious):
OK to run, but monitor
condition
Fuzzy edge cord:
OK to run,
but monitor condition
Hook wear:
Replace belt
Stone damage:
Replace belt if damage is
on edge
Bevel wear
(outboard edge only):
OK to run,
but monitor condition