Filter
Top Products
35
FEATURES AND CONTROLS
Security System (Canada)
Security Levels
The security system offers three security levels as outlined below:
Changing the Security Level
The security level can be changed at any time by using the following procedure.
1. Unlock the security system.
2. With the engine off and the park brake engaged, press and release the MODE button
repeatedly until “SECURE” displays in the gauge.
3. Press and hold the MODE button until “SETCODE” displays.
4. Press and release the MODE button once to display the current security level.
5. Press and hold the MODE button to cycle through the three security level options.
Release the button when the desired security level displays.
6. To save the displayed setting, press and release the MODE button once. “EXIT” will
display.
7. Press and hold the MODE button to exit the security menu.
Unlocking the Security System
1. Turn the ignition switch to the ON position. The gauge will display “ENtCOdE”.
2. Press and release the MODE button once to advance the digit by one increment. Repeat
until the desired digit displays.
3. Press and hold the MODE button to save the digit and advance to the next digit.
4. Repeat this process for the remaining 3 digits.
5. When the fourth digit is saved, the system unlocks and “SUCCESS” displays in the
gauge. If the passcode entered was not correct, the system remains locked and
“BAdCOdE” displays in the gauge. Re-enter the correct passcode.
Security Level Engine Starting Requirements
PASSIVE (default setting) When set to PASSIVE, use of the ignition key is required. Manual entry
of your passcode is not required.
ACTIVE When set to ACTIVE, you will be prompted to press the MODE button
within 10 seconds of turning the ignition switch off. The system will
then require manual entry of your passcode the next time the ignition
switch is turned on. See Unlocking the Security System.
If you fail to press the MODE button within the allotted time, the system
will not require manual entry of your passcode the next time the
ignition switch is turned on.
AUTO When set to AUTO, the system requires manual entry of your
passcode every time the ignition switch is turned on.