34
FEATURES AND CONTROLS
Security System (Canada)
Your SLINGSHOT vehicle is equipped with a security system for theft and roll-away
protection. The security system automatically immobilizes the engine when the ignition is
switched off, and enables the engine when the ignition is switched on and a passcode is
entered. After the passcode is entered, a slight delay before the starter engages is normal.
Change the factory-set passcode to a new passcode of your own choosing and select the
desired security setting as soon as possible after receiving delivery of your new
SLINGSHOT vehicle. Record your new passcode and keep it in a safe location. Do not place
your 4-digit passcode anywhere in the vehicle.
NOTE: The park brake must be engaged for the SECURITY menu to be accessible in the gauge.
Changing the Passcode
The factory-set passcode is 0000. Enter this passcode at step 5 the first time you change the
passcode.
1. Unlock the security system. See page 35.
2. With the engine off and the park brake engaged, press and release the MODE button
repeatedly until “SECURE” displays in the gauge.
3. Press and hold the MODE button until “SETCODE” displays.
4. Press and hold the MODE button until “OldCodE” displays.
5. Enter your existing passcode using the same process used to unlock the system.
6. If the passcode is not correct, “bAd COdE” displays. Re-enter the correct passcode. If
the passcode entered is correct, “NEWCodE” displays.
7. Enter your new passcode using the same process used to unlock the system.
8. When “CONFIRM” displays, re-enter the new passcode to confirm.
9. If the two entries do not match, “bAd COdE” displays and you’ll be returned to step 7. If
the two entries match, “SUCCESS” displays. The passcode has been changed.
10. Record your new passcode and keep it in a safe location. Do not place your 4-digit
passcode anywhere in the vehicle.