Filter
Top Products
36
FC-21 Flow Computer
Sub-menus Display Notes
ADMINISTRATIVE SETUP
OPERATOR PASSWORD
*****
SUPERVISOR PASSWORD
*****
SOFTWARE VERSION
vxx.xx
PRODUCT ORDER CODE
FC-21xxxxxxx
UNIT SERIAL NUMBER
00000
SENSOR SERIAL NUMBER
00000
Advance To
SETUP NETWORK CARD
Press Enter to begin Administrative Setup.
Enter Operator Password. (Factory Set to 0)
Enter Supervisor Password.
(Factory Set to 2000)
This display is used to show the software
version of the installed software.
This display is used to show the product order
code (model number).
This display is used to show the unit's serial
number.
This display is used to show the sensor's
serial number.
ENTER
ENTER
ENTER
6.4.23
ADMINISTRATIVE
SETUP
6.4.22
SETUP
DATALOG/PRINT
(Select_list)
ENTER
ENTER
Press enter to begin Setup Datalog/Print
routine.
Press enter when Select_list is selected to
setup print list.
Use Up and Down arrow keys to view list
status.
Press the Corresponding function key to the
items that you wish to add or remove from the
list.
Items marked with Yes will be added to the
list,
items marked with No will be removed from
the list.
The Select Print List Information display
shows the current possible Datalog size.
SET DATALOG/PRINT
SET DATALOG/PRINT
Config Select_list
PRINT LIST ITEMS
TOTAL YES
PRINT LIST ITEMS
RATE YES
PRINT LIST ITEMS
PRE 1 YES
PRINT LIST ITEMS
DataLog size =001489
Advance To
ADMINISTRATIVE SETUP
ENTER
ENTER
ENTER
ENTER
ENTER
STOP
START
List Items:
TOTAL
RATE
PRE1
TEMP
GRAND
PRE2
DENS
TIME