Filter
Top Products
Black plate (228,1)
Model "NAV2-N" EDITED: 2009/ 7/ 17
Symptom Possible cause Possible solution
Waypoints are not included in the auto
reroute calculation.
Waypoints that you have already passed are not included in the auto
reroute calculation.
If you want to go tothat waypoint again, you need to edit
the route.
Route information is not displayed. Route calculation has not yet been performed. Set the destination and perform route calculation.
You are not driving on the suggested route. Drive on the suggested route.
Route guidance is set to off. Turn on route guidance.
Route information is not provided for certain types of roads (roads
displayed in gray).
This is not a malfunction.
The auto reroute calculation (or detour
calculation) suggests the same route as
the one previously suggested.
Route calculations took priority conditions into consideration, but the
same route was calculated.
This is not a malfunction.
A waypoint cannot be added. Five waypoints are already set on the route, including ones that you
have already passed.
A maximum of 5 waypoints can be set on the route. If
you want to go to 6 or more waypoints, perform route
calculations multiple times as necessary.
The suggested route is not displayed. Roads near the destination cannot be calculated. Reset the destination to a main or ordinary road, and
recalculate the route.
The starting point and destination are too close. Set a more distant destination.
The starting point and destination are too far away. Divide your trip by selecting one or two intermediate
destinations, and perform route calculations multiple
times.
There are time restricted roads (by the day of the week, by time) near
the current vehicle location or destination.
Set [Use Time Restricted Roads] to off.
“SETTING CONDITIONS FOR THE ROUTE
CALCULATION” (page 5-13)
A part of the route is not displayed. The suggested route includes narrow streets (roads displayed in gray). This is not a malfunction.
The part of the route that you have
already passed is deleted.
A route is managed by sections between waypoints. If you passed the
first waypoint, the section between the starting point and the waypoint
is deleted (it may not be deleted depending on the area).
This is not a malfunction.
ROUTE CALCULATION AND VISUAL
GUIDANCE
11-6 Troubleshooting guide