Filter
Top Products
iPodா* PLAYER OPERATION WITH
NAVIGATION SYSTEM (if so
equipped)
Connecting iPodா
To connect an iPodா to the vehicle so that the
iPodா can be controlled with the audio system
controls and display screen, use the USB jack
located in the center console. Open the protec-
tive cover
᭺
1
on the USB jack in the center
console. Then connect the iPodா-specific end of
the cable to the iPodா and the USB end of the
cableto theUSB jackon thevehicle. IfyouriPodா
supports charging via a USB connection, its bat-
tery will be charged while connected to the ve-
hicle with the ignition switch in the ACC or ON
position.
While connected to the vehicle, the iPodா can
only be operated by the vehicle audio controls.
To disconnect the iPodா from the vehicle, remove
the USB end of the cable from the USBjack on the
vehicle, then remove the cable from the iPodா.
*iPodா is a trademark of Apple Inc., registered in
the U.S. and other countries.
Compatibility
The following models are compatible:
● iPodா 5th Generation version 1.2.1
● iPodா Classic - version 1.1.1
● iPodா Touch - version 2.0.0*
● iPodா Nano - 1st generation version 1.3.1
● iPodா Nano - 2nd generation version 1.1.3
● iPodா Nano - 3rd generation version 1.1
● iPodா Nano - 4thgeneration version 1.0.2
* Some features of this iPodா may not be fully
functional.
Make sure that your iPodா firmware is updated to
the version indicated above.
Audio main operation
Place the ignition switch in the ACC or ON
position. Press the DISC·AUX button repeatedly
to switch to the iPodா mode.
If the system has been turned off while the iPodா
was playing, pressing the VOL/ON·OFF control
knob will start the iPodா.
DISC·AUX button:
When the DISC·AUX button is pressed with the
system off and the iPodா connected, the system
will turn on. If another audio sourceis playing and
the iPodா is connected, press the DISC·AUX
button repeatedly until the center display
changes to the iPodா mode.
WHA1530 LHA1397
4-74 Monitor, climate, audio, phone and voice recognition systems