Filter
Top Products
Crankshaft, Cylinder Block, Flywheel and
11A-15-6
6A1 ENGINE (E-W) -
Drive Plate
(4) Bore all cylinders to calculated boring finish dimension.
Caution
J
To prevent distortion that may result from
temperature rise during honing, bore cylinders,
working from No. 1, No. 2, No. 3, No. 4, No. 5
and No. 6
(5) Hone to final finish dimension (piston O.D. + clearance
between piston O.D. and cylinder.)
(6) Check clearance between piston and cylinder.
Clearance between piston and cylinder:
0.02 - 0.04 mm
NOTE
When boring cylinders, finish all of four cylinders to same
oversize. Do not bore only one cylinder to an oversize.
K
Mitsubishi Motors Corporation Feb. 1997 PWEE9622