Filter
Top Products
6A1 ENGINE (E-W) -
Specifications
11A-1-7
NEW TIGHTENING METHOD - BY USE OF BOLTS TO BE TIGHTENED IN
PLASTIC AREA
A new type of bolts, to be tightened in plastic area, is currently used in some parts of the engine. The
tightening method for the bolts is different from the conventional one. Be sure to observe the method
described in the text when tightening the bolts.
Service limits are provided for the bolts. Make sure that the service limits described in the text are strictly
observed.
J Areas where the bolts are in use:
(1) Cylinder head bolts
(2) Main bearing cap bolts
(3) Connecting rod cap bolts
J Tightening Method
After tightening the bolts to the specified torque, tighten them another 90è to 100è, or 240è (twice
120è). The tightening method varies on different areas. Observe the tightening method described
in the text.
SEALANTS
Item
Water pump*
Water outlet fitting*
Engine coolant temperature sensor
Engine coolant temperature gauge unit
Specified sealant Quantity
As required
Mitsubishi Genuine Part No. MD970389 or equivalent As required
As required
3M ATD Part No. 8660 or equivalent As required
As required
Drive plate bolt 3M Nut Locking Part No. 4171 or equivalent As required
Flywheel bolt 3M Nut Locking Part No. 4171 or equivalent As required
Oil pan*
Mitsubishi Genuine Part No. MD970389 or equivalent
3M Nut Locking Part No. 4171 or equivalent
Camshaft bearing 3M ATD Part No. 8660 or equivalent As required
Cam cap 3M ATD Part No. 8660 or equivalent As required
Oil control valve 3M ATD Part No. 8660 or equivalent As required
Camshaft holder* Mitsubishi Genuine Part No. MD970389 or equivalent As required
Rocker cover 3M ATD Part No. 8660 or equivalent As required
Oil pump case* Mitsubishi Genuine Part No. MD970389 or equivalent As required
Mitsubishi Genuine Part No. MD970389 or equivalent As required
Oil pressure switch 3M ATD Part No. 8660 or equivalent As required
Oil seal case* Mitsubishi Genuine Part No. MD970389 or equivalent
*: parts sealed by foam-in-place gasket (FIPG)
K
Mitsubishi Motors Corporation Feb. 1997 PWEE9622