11A-12-6
6A1 ENGINE (E-W) -
Cylinder Head and Valves
6AE0253
MD998784
<MIVEC>
MD998772
6EN1068
MD998735
9EN0251
6AE0392
Length of shank
+
D
G
CYLINDER HEAD BOLT INSTALLATION
(1) When installing the cylinder head bolts, check that the
shank length of each bolt meets the limit. If the limit is
exceeded, replace the bolts.
Limit: max. 96.4 mm
(2) Install the washers as illustrated.
(3) Apply engine oil to the bolt threads and washers.
(4) Retighten the loosened bolts to a torque of 20 Nm in
the specified tightening sequence.
6AE0339
120
è
MB991614
(5) Make paint marks on the cylinder head bolts and cylinder
head.
(6) Give a 1 20è turn to the bolts in the specified tightening
sequence.
Caution
J
If the bolts are tightened by an angle of less than
120
è
, they may not hold the cylinder head with
sufficient strength.
J
If a bolt is overtightened, completely remove all
the bolts and carry out the installation procedure
again from step (1).
K
Mitsubishi Motors Corporation Feb. 1997 PWEE9622