Filter
Top Products
6A1 ENGINE (E-W) -
Rocker Cover and Camshaft <MIVEC>
11A-10-5
6AE0227
9N0058
Identification
Low-speed
Valve
21 mm
16 mm
High-speed cam (H)
mark location
cam (L)
CAMSHAFT
(1) Measure the cam heights. If the specified limit is exceeded,
replace the camshaft.
NOTE
Each camshaft has an identification mark on its rear end
surface.
( ) Limit
L
H
L
H
: Identification mark Standard value
IN (3) 34.34 mm 33.84 mm
36.46 mm 35.96 mm
EX (C) 34.40 mm 33.90 mm
35.86 mm 35.36 mm
6AE0228
VALVE CLEARANCE ADJUSTMENT
NOTE
Adjust the valve clearance for each cylinder and for both
intake and exhaust valves with the piston at the compression
stroke top dead center.
(1) Bring the No. 1 cylinder piston into the compression stroke
top dead center.
6AE0285
MB991477
Thickness gauge
(2) Use the special tool to loosen the adjusting screw.
(3) Insert a thickness gauge of the thickness specified below
between the low-speed cam (narrow cam) and roller.
Intake
....................................................
0.10 mm
Exhaust
.................................................
0.13 mm
(4) Screw in one of the two adjusting screws until it comes
into contact with the valve (when the turning torque
changes).
K
Mitsubishi Motors Corporation Feb. 1997 PWEE9622