Mitsubishi 6A1 SERIES Automobile Parts User Manual


 
6A1 ENGINE (E-W) -
Rocker Cover and Camshaft <MIVEC>
11A-10-3
+
C
G
OIL CONTROL VALVE INSTALLATION
(1) Apply the specified sealant to th e area shown.
Specified sealant:
3M ATD Part No. 8660 or equivalent
6AE0236
6AE0237
Protrusion
Groove
Screw
Retainer
Pad
6AE0238
+
D
G
SEMI-CIRCULAR PACKING / CAMSHAFT
HOLDER INSTALLATION
(1) Make sure that the retainer of each adjusting screw is
fitted correctly.
Caution
J
If the protrusion on the retainer is not correctly
fitted in the groove of the screw, the pad could
slip off the retainer.
(2) Apply 3 mm thick bead of foam-in-place gasket (FIPG)
to the gasket surface of the camshaft holder.
Caution
J
Since the FIPG could cause blocking of engine
oil passages, be careful not to apply FIPG to other
locations than specified.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
(3) Install the semi-circular packings.
(4) Raise the rocker arms until t he rollers come into contact
with the cams, and install the camshaft holder.
(5) Tighten the bolts in the order indicated in the illustration.
106248
7 3 1 5 9
(6) Check the torque of the Q-marked bolts. Se e section +
B
G
for the checking order.
(7) Verify that the pad of each adjusting screw is in place.
6AE0239
K
Mitsubishi Motors Corporation Feb. 1997 PWEE9622