Filter
Top Products
405
Practical hints
Flat tire
̈ After attaining a tire inflation pressure
of 26 psi (1.8 bar), press 0 on electric
air pump switch 8 (
୴ page 403).
The electric air pump is switched off.
̈ Turn the SmartKey in the starter switch
to position 0 (
୴ page 37).
̈ Detach the electric air pump.
The air hose may still be hot. Please
exercise appropriate caution.
̈ Place the electrical air pump back in
the trunk.
̈ Close the trunk lid.
̈ Drive off immediately.
The TIREFIT sealant will distribute itself
evenly inside the tire.
̈ After driving the vehicle for an initial
10 minutes, check the tire inflation
pressure using pressure gauge 9 on
the air pump.
Warning! G
If a tire inflation pressure of 26 psi (1.8 bar)
is not attained, the tire is too severely
damaged for TIREFIT to provide a reliable
tire repair.
In this case, TIREFIT cannot properly seal
the tire.
Do not drive the vehicle.
Contact the nearest Mercedes-Benz Center
or call Roadside Assistance.
Warning! G
Do not exceed vehicle speed of
50 mph (80 km/h). A TIREFIT repair is not
designed to operate at higher speeds.
The sticker must be attached on the instru-
ment cluster where it will be easily seen by
the driver.
Vehicle handling characteristics may
change. Adapt your driving accordingly.
Warning! G
If tire inflation pressure has fallen below
20 psi (1.3 bar) do not continue to drive the
vehicle.
Park your vehicle safely away from the road-
way and contact the nearest authorized
Mercedes-Benz Center or Roadside
Assistance.
Have the damaged tire replaced.
୴୴