Filter
Top Products
163
Controls in detail
Automatic transmission*
Extending gear range
̈ Briefly press the gear selector lever to
the right in the D+ direction.
The transmission will shift to the next
higher gear as permitted by the shift
program. This action simultaneously
extends the gear range of the transmis-
sion.
Canceling gear range limit
̈ Press and hold the gear selector lever
in the D+ direction until
D
reappears in
the multifunction display (
୴ page 157).
The transmission will shift from the
current gear range directly to gear
range D.
Shifting into optimal gear range
̈ Press and hold the gear selector lever
in the D- direction.
The transmission will automatically
select the gear range suited for optimal
acceleration and deceleration. This will
involve shifting down one or more
gears.
Steering wheel gearshift control
one-touch gearshifting*
With the gear selector lever in drive
position D and driving in program mode C
or S, you can limit or extend the gear
range.
If your vehicle is equipped with manual
shift program M, you can use the steering
wheel gearshift control to manually shift
the gears.
i
If you press on the accelerator when the
engine has reached its rpm limit, the transmis-
sion will upshift beyond any gear range limit
selected.
i
For information on using the steering wheel
gearshift control in program mode M, see
“Manual shift program*” (
୴ page 165).
!
Allow engine to warm up under low load use.
Do not place full load on the engine until the
operating temperature has been reached.
Shift into reverse gear R or park position P only
when the vehicle is stopped.
Avoid spinning of a drive wheel for an extended
period when driving off on slippery road
surfaces. This may cause serious damage to the
drivetrain which is not covered by the
Mercedes-Benz Limited Warranty.