Filter
Top Products
236
Controls in detail
Power windows
̈ Switch on the ignition (୴ page 37).
Opening the door windows
̈ Press and hold switch 1 or 2 at the
symbol k to the resistance point.
The corresponding window will move
downwards until you release the
switch.
Closing the door windows
̈ Press and hold switch 1 or 2 at the
symbol j to the resistance point.
The corresponding window will move
upwards until you release the switch.
Fully opening the door windows
(Express-open)
̈ Press switch 1 or 2 at the
symbol k past the resistance point
and release.
The corresponding window opens
completely.
Fully closing the door windows
(Express-close)
̈ Press switch 1 or 2 at the
symbol j past the resistance point
and release.
The corresponding window closes
completely.
i
You can also open or close the windows
using the SmartKey* (
୴ page 238) or the
retractable hardtop switch (
୴ page 237).
You can close and open the windows using the
air recirculation switch , in the control panel
of the climate control (
୴ page 178) or the
automatic climate control* (
୴ page 189).
i
After switching off the ignition (୴ page 37)
or removing the SmartKey from the starter
switch, the door windows can be operated:
ț until you open a door
ț for at least 5 minutes if no door was opened
Warning! G
If you press and hold the switch when clos-
ing the window, and upward movement of
the window is blocked by some obstruction
including but not limited to arms, hands,
fingers, etc., the automatic reversal will not
operate.
Warning! G
Driver’s door only:
If the switch is pressed again past the resis-
tance point and released within 5 seconds,
the automatic reversal will not operate.