Kawasaki KVF 750 4x4 Offroad Vehicle User Manual


 
17-78 ELECTRICAL SYSTEM
Actuator Control System
Check 5. 2WD/4WD Shift Switch Inspection
NOTE
Be sure the battery is fully charged.
Remove:
Seat (see Frame chapter)
Connect:
Controller Connector [A]
Hand Tester [B] (range: DC 10 V)
Tester (+) Connector (G) Terminal [7]
Tester (–) Connector (BK/Y) Terminal [10]
Install the needle adapters on the tester leads.
Special Tools - Hand Tester: 57001-1394
Needle Adapter Set: 57001-1457
Turn ON the ignition switch.
Push the switch to the 4WD position.
Controller Output Voltage (at 2WD/4WD Shift Switch OFF,
4WD)
Standard: about 5 V
If the reading is not standard, check the 2W D/4WD shift
switch or actuator controller unit.
Push the switch to the 2WD position.
Controller Output Voltage (at 2WD/4WD Shift Switch ON,
2WD)
Standard: 0 V
If the reading is not standard, check the 2W D/4WD shift
switch or actuator controller unit.
Check 6. Controller Unit Inspection
NOTE
Be sure the battery is fully charged.
Remove:
Seat (see Frame chapter)
Connect:
Controller Connector [A]
Hand Tester [B] (range: DC 10 V)
Tester (+) Connector (O) Terminal [2]
Tester (–) Connector (BK/Y) Terminal [10]
Install the needle adapters on the tester leads.
Special Tools - Hand Tester: 57001-1394
Needle Adapter Set: 57001-1457
Turn ON the ignition switch.
Measure the controller output voltage for the actuators.
Controller Output Voltage ( to Actuators)
Standard:
4.0.2V
If the reading is not standard, replace the actuator con-
troller unit.