Kawasaki KVF 750 4x4 Offroad Vehicle User Manual


 
6-14 CONVERTER SYSTEM
Drive Pulley
Drive Pulley Removal
Remove the t orque converter cover (see Torque Con-
verter Cover Rem oval).
Remove the three cover bolts [A] and install the drive pul-
ley holder [B].
Special Tool - Drive Pulley Holder: 57001-1520
Tighten the three cover bolts:
Torque - Drive Pulley Cover Bolts: 13 N·m (1.3 kgf·m, 113
in·lb)
Loosen the drive pulley bolt [C] (left-hand threads), hold-
ing the drive pulley with the drive pulley holder.
NOTE
The drive pulley bolt has left-hand threads. Turn the
wrench clockwise for loosening.
Remove the drive pulley bolt, two washers, and the
stepped washer, but do not remove the drive pulley
holder yet.
Remove the drive pulley [A] from the crankshaft by screw-
ing the drive pulley puller bolt [B] clockwise, while holding
the drive pulley with the drive pulley holder [C].
Special Tool - Drive Pulley Puller Bolt: 57001-1429
Drive Pulley Disassembly
Hold the drive & driven pulley holder (57001-1473) [A] and
the tapered guide of the holder (57001-1412) [B] in a vise
so that the upper s urface on the holder is 7 mm (0.28 in.)
[C] above the vise.
Special Tools - Drive & Driven Pu lley Holder: 57001-1473
Drive & Driven Pulley Holder: 57001-1412
Set the pulley onto the pulley holder.
Remove:
Drive Pulley Cover Bolts [A]
Drive Pulley Cover [B]