Filter
Top Products
12-64 FIN AL DRIVE
Rear Final Gear Case
•
Remove:
Pinion Gear Bearing Holder [A]
○
Hold the rear final gear case [A] i n a vise, and remove the
bearing holder using the socket wrench [B].
Special Tool - Socket Wrench, Hex 50: 57001-1478
○
If the holder seems too difficult to break free, apply heat
to softer the locking agent.
•
Remove:
Pinion Gear Unit [A]
Shim(s) [B]
•
Drill out the spring pin [A] with a drill bit of the 3 mm (0.12
in.) diameter and remove it.
•
Remove the needle bearing [B].
Rear Final Gear Case Assembly
[A] Rear Final Gear Case
•
Press:
Ball Bearing [B] (until bottomed)
Oil Seal [C ] (until bottomed)
Special Tool - Bearing Driver Set: 57001-1129
•
Apply Grease:
Oil Seal Lip
•
Press the face of the needle bearing [D] is flush with the
end of the housing.
•
Insert the spring pin [E].