Filter
Top Products
17-52 ELECTRICAL SYSTEM
Electric Starter System
Starter Motor Clutch Removal
•
Remove the alternator rotor (see Alternator Rotor Re-
moval).
•
Hold the rotor with the flywheel holder and take out the
starter motor clutch bolts [A].
Special Tool - Flywheel Holder: 57001-1313
•
Take out the one-way clutch [A].
Starter Motor Clutch Installation
•
Install the one-way clutch so that the flange [A] fits on the
recess [B] of the race.
•
Apply a non-permanent locking agent:
Starter Motor Clutch Bolts
•
Tighten:
Torque - Starter Motor Clutch Bolts: 34 N·m (3.5 kgf·m, 25
ft·lb)
Starter Motor Clutch Inspection
•
Remove:
Alternator Rotor (see Alternator Rotor Removal)
•
Fit the starter clutch gear into the starter motor clutch.
If the alternator rotor turns counterclockwise [A] freely
from the starter clutch gear, but not clockwise [B], the
clutch is operating correctly.
If the clutch does not operate correctly, or if it makes
noise, disassemble it and examine each part visually. Re-
place any worn or damaged parts.
NOTE
○
Examine the starter clutch gear [A]. Replace it if it is
worn or damaged.