Filter
Top Products
1.5Chapter 1 Introduction
STARTING YOUR HANDHELD AND CALIBRATING THE SCREEN
The first time you start the iQue
®
handheld, setup instructions appear on-screen. These instructions include a calibration screen,
or digitizer. Calibration aligns the internal circuitry of the handheld with its touch-sensitive screen so your handheld can detect the
task you want to perform when you tap an element on the screen. If you notice that the handheld does not respond properly when
you touch the stylus on the screen, you may need to calibrate the screen again.
To calibrate your screen again:
1. Tap the
Applications Launcher (Home) icon, and then tap Prefs.
2. In the pick list in the upper right corner of the screen, tap
Digitizer.
3. Follow the on-screen instructions, tapping the screen where indicated.
USING THE MULTI-LANGUAGE FEATURE
If your handheld has the multi-language feature, you will be prompted to select a language once you have calibrated the digitizer.
WARNING: If the language you choose on your handheld does not match the language you chose when you
installed you Palm
™
Desktop software, you could suffer data loss. If you are not sure, insert the Setup CD and
re-install the Palm Desktop software.
WARNING: In order to change to another language, you have to perform a hard reset, which will erase all
data on your handheld. If there is data on your handheld that you need to save, perform a HotSync
®
operation
before you change languages.
To select the language on your iQue 3200:
1. Tap your language choice to highlight it, then tap
OK. A confirmation screen reminds you that this setting must
match the language setting your Palm Desktop software.
2. If you select Yes to change to a language other than English, the handheld will reset.
ADJUSTING THE BRIGHTNESS OF YOUR SCREEN
To turn the backlight on or off:
1. Turn on the device.
2. Press and hold the Power button until the backlight turns on or off, then release the button.
To adjust the backlight brightness:
1. Tap the
Backlight icon, located just beside the text input area.
2. Tap and drag the brightness adjustment slider to the desired level and tap
Done.
Backlight Icon
Brightness Adjustment Slider
NOTE: Turning the Brightness up and/or keeping the Backlight “on” will reduce battery life.
Introduction: Calibration and Brightness