Filter
Top Products
GPSMAP 60CSx Owner’s Manual 31
bAsIc oPerAtIon > bAsIc oPerAtIon
Navigating a Saved Track
You can save your track log to use later as a
TracBack. When initiated, a TracBack route takes you
back to the oldest stored track log point.
To use the TracBack feature:
1. With the Saved Tracks Page for the track or
the Track Log open, highlight the TracBack
button, and press ENTER to open the
TracBack Page showing the entire track. You
are then prompted to select the point you want
to go back to.
2. Use the ROCKER to move the pointer to the
point on the map, and press ENTER to start
navigating the TracBack.
3. Select either Follow Road to route back to
the selected point using available roadways,
or select Follow Track to retrace your original
path of travel. Highlight the Don’t Ask Again
option, and press ENTER if you want to use
the same option each time you use TracBack.
The Map Page opens with directions to the
rst turn on the track at the top of the page.
4. Move in the direction of the rst turn. When
you reach the rst turn,
directions to the next
turn are shown, and so
on, until you reach
your destination.
5. To exit, press MENU,
and select Stop
Navigation.
To create a user waypoint on a saved track:
1. With a saved track shown on the map, use the
ROCKER to move the pointer to the place on the
track that you want to mark as a user waypoint.
2. Press and hold the ENTER key to open the
Mark Waypoint Page.
3. Customize the user waypoint, highlight OK,
and press ENTER to save it.