Filter
Top Products
2 GPSMAP 60CSx Owner’s Manual
gettIng stArted > unIt overvIew
Installing the Batteries
The GPSMAP 60CSx operates on two AA batteries
(not included), which are located in the back of the
unit. You can use Alkaline or NiMH batteries. See
page 67 for information on setting the battery type.
To install the batteries:
1. Remove the battery
cover by turning the
D-Ring 1/4 turn counter-
clockwise and pulling the
cover loose.
2. Insert the batteries,
observing the proper
polarity. A polarity
diagram is molded into
the battery compartment.
3. Reinstall the battery
cover by aligning the
back cover with the unit and turning the D-Ring
1/4 turn clockwise.
Remove the batteries from your GPSMAP 60CSx
when you do not expect to use the unit for several
months. Data is not lost when batteries are removed.
To install the Lanyard:
1. Place the loop of the Lanyard through the slot
at the at the upper left side on the back of the
unit.
2 Route the strap through the loop and pull tight.
Refer to page 9 for information on accessing the
microSD data card in the battery compartment.
USE BY 2009
USE BY 2009
Battery
Compartment
USE BY 2009
USE BY 2009
Battery
Compartment
Wrist Strap
Installation
Wrist Strap
Installation