Garmin 530(A) GPS Receiver User Manual


 
GNS 530(A) Pilot’s Guide and Reference
190-00181-00 Rev. H
4-6
SECTION 4
DIRECT-TO NAVIGATION
Cancelling Direct-to Navigation
Once a direct-to is activated, the GNS 530 provides
navigation guidance to the selected destination until the
direct-to is replaced with a new direct-to or flight plan,
cancelled, or the unit is turned off.
Cancelling a direct-to:
1) Press the Direct-to Key to display the Select
Direct-to Waypoint Page.
2) Press the MENU Key to display the Direct-to
Page Menu (Figure 4-13).
Figure 4-13 Select Direct-to Page Menu
3) With ‘Cancel Direct-to NAV?’ highlighted, press
the ENT Key. If a flight plan is still active, the
GNS 530 resumes navigating the flight plan
along the closest leg.
Specifying a Course to a Waypoint
When performing a direct-to, the GNS 530 sets a direct
great circle course to the selected destination. The course
to the destination can also be manually defined using the
‘CRS’ course eld on the Select Direct-to Waypoint Page.
Manually defining the direct-to course:
1) Press the Direct-to Key.
2) Use the small and large right knobs to select
the destination waypoint.
3) Press the ENT Key to confirm the selected
waypoint, then turn the large right knob
to highlight the course (‘CRS’) field (Figure
4-14).
Figure 4-14 CRS (Course) Field Highlighted
4) Turn the small and large right knobs to select
the desired course (Figure 4-15) and press the
ENT Key.
Figure 4-15 Course Field Selected
5) Press the ENT Key again to begin navigation
using the selected destination and course.
6) To re-select a direct course from present
position (or select a new manually-defined
course), simply press the Direct-to Key,
followed by the ENT Key twice.