Garmin 530(A) GPS Receiver User Manual


 
GNS 530(A) Pilot’s Guide and Reference
190-00181-00 Rev. H
10-24
SECTION 10
AUX PAGES
Setup Page: Units/Position
Setting the magnetic variation:
1) Select ‘Units/Position’ from the Setup Page,
using the steps described at the beginning of
this section.
2) The flashing cursor highlights the heading
mode field. Turn the small right knob to
select the desired heading mode: Auto, True,
or User (Figure 10-35). Press the ENT Key to
accept the selection. (The heading modes are
described at the beginning of this section.)
Figure 10-35 Heading Mode Window
3) If ‘User’ is selected, the flashing cursor moves
to the user value field (to the immediate right of
‘User’). Use the small and large right knobs to
enter the desired magnetic variation direction
and value. Press the ENT Key when finished.
Changing the units of measure:
1) Select ‘Units/Position’ from the Setup Page,
using the steps described at the beginning of
this section.
2) Turn the large right knob to highlight the desired
units of measure category (Figure 10-36).
Figure 10-36 Temp Units Window
The following categories, and corresponding units of
measure, are available:
DIS, SPD - Distance and speed in Nautical
(nautical miles/knots), Statute (miles/miles
per hour), or Metric (kilometers/kilometers
per hour) terms
ALT, VS - Altitude and vertical speed in Feet/
feet per minute, Meters/meters per minute, or
Meters/meters per second
PRESSURE - Barometric pressure in Inches or
Millibars
TEMP - Temperature in degrees Celsius or
Fahrenheit
FUEL - Fuel units in Gallons, Imperial Gallons,
Kilograms, Liters, or Pounds
3) Turn the small right knob to select the desired
units of measure for the selected category.
Press the ENT Key to accept the selection.