Garmin 530(A) GPS Receiver User Manual


 
GNS 530(A) Pilot’s Guide and Reference
190-00181-00 Rev. H
SECTION 6
PROCEDURES
6-33
When an ILS approach is first selected and
‘loaded’ (or ‘activated’), the ILS frequency is
automatically placed in the standby field. In
order to fly the final course segment of the ILS
approach, the pilot must place the ILS frequency
in the active frequency field by pressing the
VLOC Flip-flop Key. If this is not done, a ‘Select
appropriate frequency for approach’ message
appears within 3.0 nm of the FAF.
When ying a localizer-based approach (other
than backcourse) with automatic CDI switching
enabled:
GPS guidance is used while ying 1.
outbound and on the initial portion of
the procedure turn.
VLOC guidance is used on the remainder 2.
of the approach from the time the pilot
turns inbound on the procedure turn.
The localizer 3. frequency must be active
to use VLOC guidance.
When ying a localizer-based approach with
automatic CDI switching disabled:
The pilot may select VLOC guidance 1.
at any point on the approach prior to
reaching the FAF.
The localizer 2. frequency must be active to
use VLOC guidance.